Identification Guide

Identify Your Cabinets & Drawers

Face Frame (FF)

There’s a picture-frame around the opening. Existing hinges mount to the frame.

Tip: Frame pieces (stiles/rails) are often 1½–2″ wide.

Frameless / Euro (FR)

No frame. The cabinet side is the front edge.

Tip: Panel thickness is usually ¾″ (18 mm).

We only support: Face Frame → Half Overlay and Frameless → Euro. The math below helps you sanity-check measurements and reveals.

Door width (inches)

Opening width (inches)

Half Overlay target ≈ 0.50″ per side.

Enter values to calculate overlay per side.

Left door width

Right door width

Desired center gap

Opening width (inches)

Reminder: Center gap is split between both doors. Verify stile widths and any face-frame out-of-square before drilling.

Enter values to calculate per-side overlay (each door).

Door width (single door)

Case exterior width

Visible reveal (hinge side)

Visible reveal (latch side)

Note

Plate heights (0/3/6 mm) fine-tune reveals.

Enter values to estimate Euro overlay and reveals sanity-check.

Drawer system

Inside cabinet depth (inches)

Opening width (inches)

Drawer box outside width (inches)

Drawer side thickness

Quick rules

Side-Mount: Choose the longest even-inch slide that doesn’t exceed inside depth (we stock 18″ & 20″ here).
Undermount: Commonly 18″ or 21″; verify box thickness and bottom notch spec.
Clearance: Per-side clearance = (Opening width − Box width) ÷ 2.